Need a quick, easy way to toke? Make a Popper Bottle!

• One small plastic soda bottle of any size.
• A metal threaded hollow pipe (commonly found in hand pipes or lamps) the pipe should be around 3 or 4 inches long and about 1cm in diameter.
• A cigarette or lighter to melt the hole.

• Take all the labels off the bottle.
• Use a lighter to heat the plastic to bend the bottle into a shape that will not allow water to get sucked up into the mouth piece when you hit it.
• Using a cigarette or lighter, burn a small hole (slightly smaller than the diameter of the pipe) near the bottom of the bottle. Make the hole at an angle.
• Take the metal tube and screw it tightly in the hole.
• Fill the bottle with enough water to cover the bottom of the tube as you would a bong.
• Now comes the trick: Packing the Popper (tube)...to pack a popper you take a small amount of weed just enough to fit in the tube snugly but not too much or it won't pop. You take the weed and roll it into a ball. You take the ball and set it in the tube (make sure theres enough so it wont fall through) then you light it up and hit it just like a bong, Cook the weed all the way through so it's ash and when you see it start to fall hit it as hard as you can so it "pops" through the tube (hence the name "Popper") and you get a mad hit fast in your lungs.

  
   

  
  
  (Making the hole) ^
  
  (The packed tube) ^

  *Remember, you're dealing with plastic here. So be careful not to let any melted plastic drip on you! Plastic vapors are NOT good for your health!

  *When it gets too dirty to clean easily-just toss it!