Have a  tall plastic novelty cup or bottle? Put it to good use and make a dope bong!

• One tall promotional/novelty cup or bottle from a fair, amusement park or store.
• A sharp knife or scissors.
• Tape, glue or a hot glue gun.
• A bowl. (Trumpet mouthpieces work great!)

• You can either reuse the existing cup/bottle cap or make a new hole in the side for the bowl stem.
• Take out the long straw and cut off a small portion for a mouthpiece to hit from.
• Place it back in the original hole for the straw and seal tightly with tape or glue.
• Take the rest of the straw and attach to the bowl with tape or glue.
• Using the knife or scissors, make a round hole in the top of the cap for the bowl stem (straw).
• Stick in the bowl/stem and seal it tightly with tape or glue.
• Using the knife or scissors, make a carburetor hole towards the top half of the bong.
• Make sure all air leaks are sealed.
• Fill bong with enough water to cover the bottom of the straw by 2" or 3".
• Pick it.
• Pack it.
• Fire it up! 

  
  *Remember, you're dealing with plastic here. So be careful not to overheat the bowl and melt the plastic straw stem! Plastic vapors are NOT good for your health!

  *When it gets too dirty to clean easily-just toss it!